|
DAR-Tech capabilities and
services include but are not limited to the following:
Laser Services:
Sub
arc-second leveling capability, Flatness, Machine Squares,
Rotary Calibration, Geometry, Electrical Performance,
Accuracy, Repeatability, CMM Certification.
Ball Bar:
Mechanical and electrical performance tests, check
circular interpolation, check ballscrews, check backlash,
squareness, Servo mismatch, check looseness / fit, repair
and PM planning.
NC, CNC, PLC, PC:
Redesign. retrofit or modification, complete repair or
replacement, rewire.
General Control Repair or Replacement,
Relay (or hard) Logic:
Redesign, retrofit or modification, complete
troubleshot, repair or replacement, rewire.
General Repair or
Replacement:
Draw bar testing and repair, general mechanical redesign,
retrofit or modification, complete troubleshoot, repair or
replacement.
Complete Drive Motor, Spindle
Motor and Control:
Redesign, retrofit or modification, complete repair or
replacement, setup, alignment
Complete Hydraulic System
Repair or Replacement:
Redesign, retrofit or modification, complete diagnostics
or repair, re-plumb, valves, cylinders.
Complete High and Low
Pressure Coolant System Repair or Replacement:
Redesign, retrofit or modification, complete diagnostics
or repair, re-plumb, valves, pumps, filters and regulators.
Complete Pneumatic System
Repair or Replacement:
Redesign, retrofit or modification, complete diagnostics
or repair, re-plumb, valves, cylinders, filters / regulators
/ lubrication.
Complete Lubrication System
Repair or Replacement:
Redesign, retrofit or modification, complete repair or
replacement, re-plumb, valves, pumps, filters and
regulators.
Complete Bearing, Wiper and
Seal Repair:
Bearing loading, nut loading, backlash adjustment,
hydrostatic bearings, scraped, bearings, linear bearings /
roller packs, mounting area repair, mounting area
resurfacing, wear surface repair / refinish.
Scraping:
All areas, mounting area repairs, mounting area
resurfacing, wear surface repair / refinish, Moglice
application, Turcite application, Roulon application.
Complete Machine Moving and
reinstallation (turnkey):
Pre-move alignment / calibration assessment.
Decommissioning, rebuild / repair, recommissioning, final
alignment and certification.
Complete Machine Assessment:
Mechanical, Electrical, Electronic, Hydraulic,
Pneumatic, Geometry, Squareness, Alignments, (straightness,
parallelism), Accuracies, Repeatability, Reliability.
Complete PM (preventive
maintenance) Programs:
Complete documentation
and reporting, ball bar, setup and align, master pallet
comparison, accuracy, squares, spindle setup, draw bar test,
clean control panels, clean boards, silver migration tests,
wiper replacement, seal replacement, bearing replacement,
backlash (test / adjustment / compensation), fan test or
replacement, filter and screen replacement, general
cleaning, general lubrication.
Onsite Maintenance Service
Programs:
Complete documentation and reporting. Complete PM as
described above, all other services as described here.
Robot Repair / Rebuild:
Move and re-install, re-design cell, retrofit,
modification, modernization, complete diagnostics and
repair, setup and alignment.
Custom Fabrication:
Design, Simulation, discrete event simulation, controls,
machine modification and additions.
Ball Screw Repair / Rebuild:
Level 1 repair, emergency repair, replacements, (reball,
grind, redesign). Ball/ACME Lead Screw & Nut assemblies,
also cut and ground gears, splines (up to AGMA14) Emergency
repairs and replacements as available.
Panel Shop:
Design, build (total), sub-assemble, test.
Machine Shop:
Design, fabrication, cut (various machining procedures),
grind / polish, press, sub-assemble, test.
|
